I only changed one thing each time and tried for hours…nothing. I have tried the manual laser entry using GRBL and anything else listed with GRBL and systematically tried every port on the computer, every console selection, using the USB option. I know the laser works because one time it miraculously reacted to my commands to trace the perimeter of my imported piece…however I have never been able to repeat that despite not changing any of the connections, ports, etc for that one run. Well, I am sorry to report that I still am unable to connect to my Sculpfun S9 laser using my MacBook Pro running Monterey.
If someone has this setup correctly and can show a screen shot of the setup that would be appreciated.Hello again. When I turn on the laser it says x and y are 0,0 yet when I try to move it via the software using the arrows, it says it moves. I followed a previous post on this issue that was closed in Feb but still no go.
The Sculpfun doesn’t have any limit switches installed. I’ve tried numerous settings and manually pushing it to the corner opposite (against the wall) and then turning on the laser, etc… Unless I use current position I can’t seem to get it working properly. XxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxĬontrxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx I have the physical machine oriented horizontally against a wall with the controller facing toward me on the left side. Having never used it without the expansion kit, I’m not sure if I’d have the same issue.įor some reason, absolute coordinates does not seem to work.
I purchased the Sculpfun S9 with the expansion rails.
0 kommentar(er)
